Removing the Power Button Board
1. Perform the
2. Perform the
3. Release the latch (1) from the mainboard then disconnect the power button cable (2).
4. Release the power button board from the adhesive tape securing it (1) then tilt the power
button board (2) and detach it from the upper case.
NOTE:
3-38
Downloaded from
www.Manualslib.com
"Removing the Lower
"Removing the Battery
Figure 3-58. Power Button Cable
Figure 3-59. Power Button Board Adhesive Tape
NOTE:
A circuit board that is > 10cm
Figure
3-59. Follow the local regulations for disposing this type of circuit board.
manuals search engine
Case" procedure described on page 3-9.
Pack" procedure described on page 3-10.
2
has been highlighted with a yellow rectangle in
0
Machine Maintenance