Center Margin; Outer Margin; Orientation - Toshiba e-Studio 350 Printing Manual

If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge
binding is used.
Example: The command to select left to right page layout for booklet printing mode is
"lp –o left2right=on filename".

— Center Margin

The booklet mode center margin can be selected using the following options.
Example: The command to select the center margin value for booklet printing mode is
"lp –o centremargin=value filename".

— Outer Margin

The booklet mode outer margin can be selected using the following options.
Example: The command to select the outer margin value for booklet printing mode is
"lp –o outermargin=value filename".

— Orientation

The following orientation options are available.
318
Option Value Alternate
Value
left2right=on ON
Option Value Alternate
Value
centermargin
=value
Option Value Alternate
Value
outermargin
=value
Option Value Alternate
Value
portrait
Description
Select left to right page layout for booklet printing mode.
This is the default setting.
If the value is ON then the layout of the pages is from Left to
Right as shown in the figure below.
Description
Select the center margin value for booklet printing mode.
This value specifies in pixels the Center Margin or the "Gutter".
This is in addition to the center margin already specified by the
application. The valid range for value is 0 – 300. Default is 0.
Description
Select the outer margin value for booklet printing mode.
This value specifies in pixels the Outer Margin or the "Creep"
per page, which should take place while printing a booklet. The
valid range for value is 0 – 18. Default is 0.
Description
Print the document in portrait orientation.
Printing Guide — Printing from UNIX