Toshiba e-Studio 350 Printing Manual page 174

NOTE:
12.
Configuring Macintosh AppleTalk printing
•
PREPARATION:
174
Offset Tray — Select this when the Offset Tray is installed (only for
e-STUDIO450 Series and e-STUDIO280 Series).
• When you select "Multi-Position Stapler" or "Multi-Position Stapler and
Hole Punch", the saddle-stitching function will be selectable for print-
ing. However, saddle-stitching is available only when the Sad-
dle-stitch Finisher is installed.
— Lower Drawer (only for e-STUDIO280 Series)
Not Installed — Select this when the Lower Drawer is not installed.
Installed — Select this when the Lower Drawer is installed.
— Pedestal
Not Installed — Select this when no pedestal is installed.
Pedestal 1 — Select this when the Paper Feed Pedestal is installed.
Pedestal 2 — Select this when the Paper Feed Pedestal and Drawer Module are
installed.
LCF — Select this when the Large Capacity Feeder is installed.
— ADU (only for e-STUDIO280 Series)
Not Installed — Select this when the ADU is not installed.
Installed — Select this when the ADU is installed.
Click [OK].
Before installing the printer driver for AppleTalk printing on Macintosh, check with
your system administrator to make sure of the following:
- This equipment is connected to the network and turned on.
- The AppleTalk settings is correct.
1.
Click Apple menu and select [Chooser].
• The Chooser dialog box appears.
Printing Guide — Installing Client Software for Macintosh