Epson StylusPro10000 Printer Manual page 111

Error messages (continued)
Message Light
SERVICE REQ. All lights
<00000100> flashing
TURN PWR OFF —
AND ON
UNABLE TO —
PRINT
WRONG Ink Out light(s)
CARTRIDGE on
INVALID
CARTRIDGE
NOZZLE CHECK
ERROR
COMMAND ERROR
Monitoring and Configuring the Printer
Explanation
The waste ink system
is full.
This message appears
after you clear a paper
jam.
You tried to print while
an error condition was
present or the ink
compartment cover
was open.
You tried to install the
wrong ink cartridge.
The nozzle check
pattern did not print
correctly.
You're using the wrong
printer driver.
Damaged data was
sent to the printer.
5-7
Response
Contact EPSON to have the waste ink system
replaced.
Press the Power button to turn the printer off
and back on again.
After 3 seconds the message disappears.
Press the Pause button to exit SelecType
mode. If the message appears again, clear the
error before you print.
If you are installing ink cartridges for the first
time, you must install the cartridges that came
with your printer.
If you are replacing ink cartridges, check the
package and product code. You must use the
ink cartridges designed for your printer. Other
cartridges will not work.
Press and hold the Cleaning button on the
control panel for at least 3 seconds to begin
cleaning the print head.
Make sure you installed the Stylus Pro 10000
driver if your printer is the Photographic Dye Ink
model, or the Stylus Pro 100000CF driver if
your printer is the Archival Ink model.
To clear the data, press the printer's Power
button to turn the printer off. Wait for about a
minute, then turn the printer on again.
| 5-7