Epson StylusPro10000 Printer Manual page 110

5-6 | Monitoring and Configuring the Printer
Error messages (continued)
Message Light
PAPER JAM Paper Out
light flashing
PAPER NOT CUT Paper Out
light flashing
PAPER NOT Paper Out
STRAIGHT light flashing
PAPER OUT Paper Out
light on
LOWER PAPER Paper Out
SET LVR light on
RELOAD PAPER Paper Out
light on
REMOVE PAPER Paper Out
light on
SERVICE REQ. All lights
<error number> flashing
Explanation
Paper has jammed in
the printer.
Roll paper was not cut
completely.
Cut paper did not fall
off.
Paper slipped and fed
into the printer at an
angle.
No paper is loaded.
Paper ran out.
Paper set lever was
released during the
printing process or
another operation.
Paper could not be
reversed into the
printing position.
Image is too wide for
the paper loaded in the
printer.
Paper is not fully
ejected.
PAPER NOT CUT error
was cleared.
Paper is too thick for
head cleaning.
An error has occurred.
5-6
Response
Remove the jammed paper. See page 7-11 for
more information.
Cut the paper manually, then remove the cut
paper from the printer. Reload paper, as
described on page 1-4.
Remove the cut paper from the printer. Reload
paper.
Reload paper, making sure the edges are
straight and aligned with the vertical row of
holes at the paper exit.
Load paper.
Remove any printouts or paper remaining in the
printer and load more paper.
If the message appears during a print job, reset
the printer by pressing the Pause button for 3
seconds. Then load paper and resend the job.
Push the paper set lever all the way in, to the
secured position. Start printing again from the
beginning for best results.
Remove the paper. Reload it so that the bottom
edge is straight and aligned with the vertical
row of holes at the paper exit.
Resize your image or load wider paper.
Cut the paper at the paper insertion slot, then
reload paper.
Reload paper.
Pull the paper set lever out to remove the
paper. Head cleaning automatically starts. After
cleaning, reload paper.
Note the error number, and turn the printer off
and then on. If the message remains, contact
EPSON as described on page 4.