Table of Contents
Advertisement
Switching from 2D to 3D
You can view the picture in either 2D or 3D mode when the content itself is 2D. Use the
remote control or the control panel on the projector to switch between modes.
Requirements:
•
Support 720p, 1080i, 1080p 50/60Hz from HDMI port. See
page
1.
Do one of the following:
•
Using the remote control
i. Press 3D MENU
•
Using the OSD menu
i. Press MENU/EXIT.
ii. Press
iii. Press
2.
Press
3.
Press
Using 2D to 3D Deep
You can set the strength of the 3D effect by using the 2D to 3D Deep function. To make
objects appear farther away, use Inward 1, Inward 2 or Inward 3. To make objects appear
closer, use Outward 1, Outward 2 or Outward 3.
To use this function, go to the DISPLAY > 3D menu. Press
press
/
to select Inward 1, Inward 2, Inward 3, Outward 1, Outward 2 or Outward 3.
Using 2D to 3D Curve
To adjust the perspective projection level use the 2D to 3D Curve function. The image is
projected by using a flat, inverse, or direct curve.
To use this function, go to the DISPLAY > 3D menu. Press
press
/
to select 0, 1, 2 or 3.
Setting 3D functions
The following functions allow you to enable or disable 3D functionality.
Requirements:
•
PC: PC with graphic card with stereo capability (Quad buffer feature) and can run
at 120Hz/60Hz refresh rate.
•
Video: standard NTSC/PAL DVD player to output 60Hz/50Hz movie.
•
HDMI: Support 720p 50/60Hz Frame Packing, 1080i 50/60Hz Side-by-Side, and
1080p 24Hz Frame Packing format.
•
Non HDMI: Frame Sequential / Top-Bottom.
•
To enjoy the 3D function, first enable the Play Movie in 3D setting found in your DVD
devices under the 3D Disc Menu.
•
The brightness level of the projected image will decrease when viewing 3D content with
3D glasses.
34
Operation
65.
.
/
until the DISPLAY menu is highlighted.
to go to 3D menu and press ENTER.
to go to 2D to 3D.
/
to enable or disable the function.
"Timing chart" on
to go to 2D to 3D Deep and
to go to 2D to 3D Curve and
Advertisement
Table of Contents
