Table of Contents
Advertisement
Switching input signal
The projector can be connected to multiple devices at
the same time. However, it can only display one full
screen at a time. When starting up, the projector
automatically searches for the available signals.
Be sure the Advanced menu - Display > Auto Source
Search menu is On if you want the projector to
automatically search for the signals.
To select the source:
1. Press SOURCE. A source selection bar appears.
2. Press
/
until your desired signal is selected and press OK.
Once detected, the selected source information will appear at the corner of the screen for
seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to
search for another signal.
• The brightness level of the projected image will change accordingly when you switch between different
input signals.
• For best display picture results, you should select and use an input signal which outputs at the
projector's native resolution. Any other resolutions will be scaled by the projector depending upon the
"aspect ratio" setting, which may cause some image distortion or loss of picture clarity. See
Ratio on page
30 Operation
41.
Aspect
Advertisement
Table of Contents
