Table of Contents
Advertisement
Setting the 3D Direct Sync Function
1.
Do one of the following:
•
Using the remote control
i. Press 3D MENU
•
Using the OSD menu
i. Press MENU/EXIT.
ii. Press
/
iii. Press
to go to 3D menu and press ENTER.
2.
Press
to go to 3D Direct Sync.
3.
Press
/
to select Auto/On/Off.
•
Auto: If projector detects 3D timing, then 3D Direct Sync is automatically set;
otherwise 3D Direct Sync will be Off.
Auto detection mode supports an HDMI source only.
•
On: If 3D timing is not detected, set 3D Direct Sync to On, then select 3D Format
from the 3D menu.
•
•
Setting the 3D Sync Invert Function
You can switch between the image for the left eye and the right eye for the more natural 3D
viewing.
1.
Do one of the following:
•
Using the remote control
i. Press 3D INVERT
•
Using the OSD menu
i. Press MENU/EXIT.
ii. Press
/
iii. Press
to go to 3D menu and press ENTER.
2.
Press
to go to 3D Sync Invert.
3.
Press
/
to enable or disable the function.
If the 3D image is distorted, you can try to enable 3D INVERT and wait for 5 seconds for the
images to switch for the more comfortable 3D viewing experience.
.
until the DISPLAY menu is highlighted.
Check image format and select the proper 3D format.
For non-HDMI sources set 3D Direct Sync to On and select the proper 3D
format.
.
until the DISPLAY menu is highlighted.
Operation
35
Advertisement
Table of Contents
