Leaving The Setup Program - Epson Y16499100301 User Manual

Leaving the Setup program

When you finish using the Setup program, press t until the
cursor block is on Exit and press
list of the current settings you just made. Check the list to
make sure all the information is correct.
Below the list you see this menu:
Change settings
without saving
Exit
* * EXIT AND SAVE * *
If any setting is incorrect, press
is displayed again, and you can correct the setting.
If you did not make any changes or if you want to cancel
the changes you made, press 1 to select
and press
Enter.
When the settings are correct, press 1 to select * * EXIT
AND SAVE * *, and press
resets the computer using the new configuration. If the
reference diskette is in drive A, remove it and insert the
MS-DOS diskette in the drive.
If the computer displays a Setup error message during the
power-on self test, run Setup again and check all your settings.
Note
If you have the hard disk model Equity LT, go on to
Chapter 2 and complete all the procedures there to prepare
your hard disk for use. If you do not have a hard disk, go on
to Chapter 3.
1-28
The screen displays a
Enter.
The main Setup menu
Enter.
Exit
At this point, the program
Enter.
Setting Up Your System
saving,
without