Table of Contents
Advertisement
5.
Remove the diskette from drive B and insert the blank
diskette in the drive.
DISKCOPY
If it is not, DISKCOPY formats the diskette. You see the
message:
Formatting while copying
The copy operation begins when the format is complete.
You see these messages:
Copying
9 Sectors/Track, 2 Side(s)
6.
When the copy is complete, the screen displays this
message:
Copy another diskette (Y/N)?
Your diskette has now been copied and you can either
make another copy or leave the DISKCOPY command.
Press Y to perform another copy or
DISKCOPY command.
Using the COPY command
You can use the COPY command to copy files in several
ways. You can do the following:
Copy individual files from one diskette to another or to the
l
same diskette
Copy a group of files using wildcard characters
l
Copy one or more files and give them new names.
l
A few simple rules apply when copying files:
You must tell MS-DOS where to find the source file and
l
where to store the target file.
You cannot create a new file with the same name as an
l
existing file.
4-12
checks to see if the new diskette is formatted.
40 tracks
Using MS-DOS With the Equity LT
to end the
N
Advertisement
Table of Contents
