Epson Y16499100301 User Manual page 23

4. Connect the other end of the cable to the printer as shown
below. To secure the cable, squeeze the clips at each side of
the printer connector and click them into place.
5. Plug the printer's power cable into an electrical outlet.
6. Be sure to turn off DIP switch 1 on the back panel as
described below under "Setting the DIP Switches" to let
your computer know a printer is connected.
Note
If you plan to use an external 5 f -inch diskette drive with
your Equity LT, it must be connected to the parallel port.
Therefore, you cannot have both a parallel printer and the
diskette drive connected at the same time. Be sure to turn on
DIP switch 1 on the back panel to select the external drive. See
"Setting the DIP Switches" below.
1-8
Setting Up Your System