Starting The Setup Program - Epson ActionNote User Manual

The configuration you define through SETUP is stored in a
special area of memory called CMOS RAM. This memory is
backed up by a battery, so it is not erased when you turn off or
reset the computer. Whenever you start the computer it checks
the settings, and if it discovers a difference between the
information in CMOS RAM and your system's configuration, it
prompts you to run SETUP. You see a message such as the
following:
CMOS memory mismatch
Run SETUP
You also see the following prompt at the bottom of the screen:
Press F1 to continue or Delete to run SETUP
If this happens, press
setting.

Starting the SETUP Program

To start SETUP, make sure there is no diskette in the diskette
drive; then turn on your computer. (If your computer is already
on, turn it off, wait 20 seconds, and then turn it on again.) After
the self test, you see the following prompt at the bottom of the
screen:
Press Delete to run SETUP
As soon as you see this message, press
If you do not press
the computer starts loading the operating system and you will
not be able to run SETUP. If this happens, restart or reset the
computer and try again.
2-2 Running SETUP
to run SETUP and correct the
within approximately five seconds,