Table of Contents
Advertisement
of time. The default time period is two minutes. You can
change it to a time between one-half minute to five minutes, in
half-minute increments. If you do not want the backlighting to
be turned off at all, select no time limit so it remains on unless
you turn off the computer.
After the backlighting goes off, it remains off until you
press any key on the keyboard. As soon as you press a key,
the backlighting comes back on.
To change the backlight period, follow these steps:
1. Press 1 to select Backlight period and press
see:
2 . 0
* SAVE A SETTING *
2.
To increase the time period, press +. To decrease the time
period, press -. The time increases and decreases in half-
minute increments: .5, 1.0, 1.5, etc. If you reach 5.0 and
press +, the screen displays the following:
No time limit
This means that the computer will not turn the
backlighting off at all.
3.
After you select the time period you want, press 1 to move
the cursor block to * SAVE A SETTING * and press
to return to the Setup menu.
Enter
Changing the serial port (RS-232C) settings
Use the Primary serial port and Secondary serial port
options to change the default parameters for the serial port(s)
in your computer. If you are not using the serial port at all,
you don't need to do anything with this part of the Setup
program, and you can go on to "Leaving the Setup program"
below.
Setting Up Your System
Minutes
Enter. You
1-25
Advertisement
Table of Contents
