Table of Contents
Advertisement
The cylinder number counts down to 0.
At the end of the test, you see a table of the results of the
test. For example, for a 20MB hard disk with three bad tracks,
you see the following:
BAD TRACKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0
READ ERROR TRACKS.. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
GOOD TRACKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Press Enter to return to the menu
Press
when you have viewed the table. Don't worry if
Enter
there are some bad tracks on the disk. They have been
registered by the manufacturer and will not be used to store
data.
Run all above checks
To run all the tests on the menu in sequence, press
then
Enter.
When you choose this option, all checks for the hard disk
drive and controller are performed automatically in sequential
order. Although you do not start each test, you must still
supply the appropriate responses to progress from one test to
the next. This is the first prompt you see:
The data on the highest physical cylinder may be
destroyed by this check.
Enter Y to start this check.
Enter
N to return
Press Y and then
Exiting System Diagnostics
When you finish running the system diagnostics, press 0 to
exit the program. When the MS-DOS command prompt
reappears, remove the reference diskette.
Performing System Diagnostics
to the menu.
to continue with the test.
Enter
3
2457
5 and
D-23
Advertisement
Table of Contents
