Replacing Or Adding A Processor - Gateway E-5400 System Manual

Replacing or adding a processor

The system is compatible with the Intel
faster processors with 133 MHz front-side bus (FSB). Up to two processors may
be installed in the system.
When replacing a processor, or adding an additional processor, order a
Pentium III processor upgrade kit from Gateway. The kit includes the Pentium
III processor, a fan/heatsink, and a disposable electrostatic wrist strap.
Caution
To replace a processor:
1
Turn off the system and disconnect the power cord and modem cord (if
installed) and all other external peripheral devices.
2
Open the case by following the instructions on page 17. (See "Preventing
static electricity" on page 15.)
3
Disconnect the power supply cable of the processor fan from the CPU
fan connector on the system board.
4
Place the head of a flat-bladed screwdriver behind the tab on one side
of the processor retention bracket holding the processor to be removed.
5
Push the handle of the screwdriver toward the processor. When the tab
that locks the processor in place opens, lift up slightly on the side of the
processor.
28
System Components
A heatsink or fansink must be installed on each processor.
Installing a processor without a heatsink or fansink could
result in damage to, or failure of the processor.
® ®
Pentium III 667 and 733 MHz and
Screwdriver
Tab