Table of Contents
Advertisement
CHAPTER 10: SEGMENT OPTION GENERATOR
EPROM Type
This option is not available for S1C63 Family microcomputers.
User's Name
Enter your company name. Up to 40 characters can be entered. You can use English letters, numbers,
symbols, and spaces. The content entered here is recorded in the USER'S NAME field of the segment
option document file.
Comment
Enter a comment. Up to 50 characters can be entered in one line. You can enter up to 10 lines. You can
use English letters, numbers, symbols, and spaces. Use the [Enter] key to create a new line. All
comments should include the following information:
• Place of business, your department or section
• Address, telephone number, and facsimile number
• Other: Technical information, etc.
The content entered here is recorded in the COMMENT field of the segment option document file.
When you have finished entering the above necessary items, click [OK]. The setup contents are saved,
and the dialog box is closed. The setup contents take effect immediately. If you click [Cancel], current
settings will not be changed and the dialog box is closed.
Notes: • File name specification is subject to the following limitations:
1. The number of characters that can be used to specify a file name including the path is 2,048.
2. The file name itself (not including the extension) can be up to 15 characters, and the exten-
sion up to three characters.
3. The file name cannot begin with a hyphen (-), nor can the following symbols be used as part
of directory names (folder names), file names, and extensions:
/ : , ;
? " < > |
• The symbols shown below cannot be used in the User's Name and Comment:
$ \ | `
(3) Setting segment outputs
The LCD drive circuit of an S1C63 Family chip that has had segment options set normally allows
selecting the segment output and DC output for every two pins (in certain types of microcomputers,
individually for each pin). Segment output should be specified when using the pins for driving an
LCD panel.
Segment output ports have a built-in segment decoder allowing any address and data bit in the
display memory area to be assigned to any segment. When the segment memory bit is set to 1, the
assigned segment lights up; when the bit is set to 0, the segment dims. Segments and display memory
bits correspond individually, so that you cannot assign one display memory bit to multiple segments.
Therefore, all segments must be assigned different addresses and data bits.
For details about the display memory map and segment assignment, refer to the Technical Manual for
each type of microcomputer.
In the explanation below, the chip is assumed to have four common pins, COM0 to COM3.
Follow the procedure below to assign segments:
1. From the [Memory Address/Data bit] table, select the memory address/data bit you want to
assign by clicking the appropriate cell. The cell changes color to blue.
If you select an incorrect cell, select a correct cell.
The horizontal rows of the table correspond to display memory addresses. The hexadecimal
number shown to the right of the "Memory Address/Data bit" title is the base address of display
memory, with only the lower byte of address being displayed in each row of the table. The vertical
columns of the table correspond to data bits.
256
EPSON
(S1C63 FAMILY ASSEMBLER PACKAGE)
S5U1C63000A MANUAL
Advertisement
Table of Contents
