Writing The Program Into The Microcontroller; Figure 2-4 Completing The Build; Figure 2-5 Opening The File To Write - Fujitsu FR Family FR60 Lite User Manual

AN07-00180-3E
The message pane at the bottom of the window shows a message that tells no error was found as shown in
"Figure 2-4 Completing the build" to inform you of successful build.

Figure 2-4 Completing the build

2.1.2

Writing the program into the microcontroller

Preparation
Set MODE on the board to "PRG" in advance.
Select "Start" → "All Programs" → "FUJITSU FLASH MCU Programmer" → "MB91F267NA" to
activate PC Writer.
To select a file to be written as shown in "Figure 2-5 Opening the file to write", click the "Open" button.
Click this.

Figure 2-5 Opening the file to write

- 38 -