Notes On Monitor Debugger; Figure 2-36 Stopping The Program - Fujitsu FR Family FR60 Lite User Manual

As shown in "Figure 2-36 Stopping the program", click the × button for closing the application on the
upper right side of the window to stop running the program.
Although a warning dialog for the stop is displayed, click the "Abort" button in any case.
2.2.6

Notes on Monitor Debugger

Note that Monitor Debugger has the following restrictions.
・ Only up to 16 break points can be set. No more break point can be set, so to set other break points,
cancel some of those already set and set new break point.
・ While Monitor Debugger is running (after Monitor Debugger is activated in 2.2.2 Activating
SOFTUNE and configuring the debug settings), it is prohibited to press the Reset SW on the board;
it causes Monitor Debugger to stop.
・ For the operation of Monitor Debugger, UART0 is used. If you modify the sample program or
apply it to some other purpose, remind this.

Figure 2-36 Stopping the program

- 59 -
AN07-00180-3E