Appendix E Writing To Flash Microcontroller Using Parallel Writer - Fujitsu F2MC-8FX Hardware Manual

F2mc-8fx 8-bit microcontroller
Hide thumbs Also See for F2MC-8FX:
Table of Contents

Advertisement

APPENDIX E Writing to Flash Microcontroller Using Parallel Writer

APPENDIX E Writing to Flash Microcontroller Using Parallel
This section describes writing to flash microcontroller using parallel writer.
Writing to Flash Microcontroller Using Parallel Writer
Table E-1 Parallel Writer and Adaptor
Package
FPT-64P-M23
FPT-64P-M24
NOTE:
For information on applicable adapter models and parallel programmers, contact the following:
Flash Support Group, Inc. TEL: +81-53-428-8380
Sector Configuration
The individual sectors of Flash memory correspond to addresses used for CPU access and programming by
the parallel programmer as follows:
• MB95F176JS/MB95F176JW (32 Kbytes)
Flash memory
32 Kbytes
*: Programmer addresses are corresponding to CPU addresses, used when the parallel programmer
programs data into Flash memory.
These programmer addresses are used for the parallel programmer to program or erase data in Flash
memory.
How to Write
1) Set the type code of the parallel programmer to 17222.
2) Load program data to programmer addresses 0000
3) Programmed by parallel programmer
576
Writer
Compatible adaptor model
CPU address
8000
H
FFFF
H
TBD
TBD
Programmer address*
0000
H
7FFF
H
to 7FFF
H
Parallel writer
TBD
TBD
.
H

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mb95170j series

Table of Contents