Grid Block 1 Assembly Removal - Lexmark Optra C710 Service Manual

5016-001

Grid Block 1 Assembly Removal

1. Remove the left side cover, refer to the
Removal" on page
2. Remove the HVPS assembly, refer to the
Assembly Removal" on page
3. Remove the three (3) screws [A] from the block assembly.
4. Remove the block assembly.
5. Disconnect the waste toner sensor board cable.
Note: When replacing the grid 1 block assembly, be sure not to
damage or deform the high voltage contact.
4-16
Service Manual
4-3.
4-20.
"Left Side Cover
"HVPS Board