Advertisement
Available languages
Available languages
How to Start:
1.
Place On/Off switch to "OFF".
2.
Plug the power cord into the
grounded outlet.
NOTE: Before turning the inflator on
know the desired pressure (measured
in PSi).
3.
Place On/Off switch to "ON" to
start inflator, if using the pressure
gauge watch it closely and when
it reaches the desired pressure
place the on/off switch in the
"OFF" position.
IMPORTANT:
Watch inflatable
carefully while filling; do not overfill.
IMPORTANT: While inflating objects
the pressure gauge will not read
correctly. Sometimes the gauge will
read very high. Turn the unit "off"
and allow the needle to settle, this
will provide an approximate
reading.
Stop and check the pressure reading
frequently when inflating.
NOTE: The pressure gauge on the
unit is for general reference only. To
ensure the most accurate pressure
reading use a separate pressure
gauge (not included) designed for the
object being inflated.
NOTE: When the unit has been
turned off, it is normal to hear a short
hiss of air being released.
2.
Wipe plastic parts clean using
1.
Place the On/Off switch to "OFF"
mild soap and warm water.
and unplug the cord.
t.
2.
Set the On/Off switch to "OFF"
and unplug the cord.
Store accessories in the storage
bag located on back of unit.
The storage bag has a smaller
compartment
to hold sma!ler
accessories.
Smaller
Compartment
Wind the electrical cord loosely
around the inflator and snap it
onto itself for storage.
4.
Coil the air hose around shroud
and snap into hose snap.
5.
Hose Snap
Store the inflator in a clean and
dry location.
A10087
14-ENG
Advertisement
