Front Angled View Of The Vision 2448 - Vision 1612 User Manual

(Figure 1.3) Moveable gantry flatbed table format.
Shown here is a top view of the Vision 2424.
10. Engraving Motor
3. X-Axis
Lead Screw
2. X-Axis
Linear Rails
1. Table Base Plate
(Figure 1.3a) Front angled view of the Vision 2448
4. Gantry Assembly
1. Table Base Plate. This is the large flat plate upon which everything else is mounted. All
mechanical alignments are referenced to this plate, so the space upon which you place the
engraving table must be a reasonably level surface.
(Always carry the table by the base plate only.) An optional t-slot table may be installed on the
table base plate. Router tables include a t-slot table as standard.
2. X-Axis Linear Rails. Mounted under the table base plate are steel rails with sealed
bearings, which allow the motion of the gantry in the X-axis direction.
5. Carriage Assembly
8. X-Axis
Stepper Motor
5. Carriage Assembly
1. Table Base Plate
2. X-Axis Linear Rails
4. Gantry Assembly
7. Y-Axis
Stepper Motor
9. Material Guides
6. 25 Pin
Breakout Box
9. Material Guides
6. 25 Pin
Breakout Box
Chapter 1
Page 11