Table of Contents
Advertisement
Introduction
5
1
Introduction
About This Manual
This manual is designed to provide you with information about your Vision Series 5 Controller, Engraver
or Router. Beginning with unpacking the machine and continuing through installation, operation and
maintenance, this manual does not attempt to teach the user how to become an expert in engraving,
computer usage, or engraving software usage. Some previous knowledge of engraving terms and the
engraving process is certainly beneficial. For information on the Vision Engraving Software, see
the Vision Engraving Software manual. For more information on your individual computer system,
see your computer's user manual or contact your computer distributor.
Please call or email your Vision distributor or the Vision service department for assistance if you have
any questions. The Vision service department phone number is 1-602-439-0600 and the email address
is service@visionengravers.com.
1.1
Disclaimer and Warranty Information
Limits of Liability / Disclaimer of Warranty
The information contained within this manual has been carefully checked and is believed to be accurate,
however, Vision makes no representations or warranties for this manual, and assumes no responsibility
for inaccuracies, errors, or omissions that may be contained within this manual. In no event shall Vision
be liable for any loss of profit including (but not limited to) direct, indirect, special, incidental,
consequential, or other damages resulting from any defect or omission in this manual, even if previously
advised of the possibility of such damages.
In the interest of continued product development, Vision reserves the right to make improvements to this
manual and the products it describes at any time, without notice or obligation.
Limited Warranty:
Vision Computerized Engraving and Routing Systems
Vision Computerized Engraving and Routing Systems (Vision) warrants that for a period of two (2) years
from the date of shipment to the original purchaser of either a Series 5 Controller, Phoenix, Vision or
Table Retrofit (the System), that the System will be free from defects in material and workmanship under
normal use and service. Upon written notification, we will transfer the remaining warranty to a new
customer. This warranty shall cover all elements except for items covered by separate manufacturer's
warranties and consumable items. "Consumable" items include, but shall not be limited to, belts,
brushes, lubricants, and cutters furnished with the System, for which no warranty is provided.
In the event a defect is discovered during the warranty period, within thirty days of discovery, but no later
than the last day of the warranty period as described above, the user shall contact Vision for instructions
regarding disposition of the problem. Vision shall, at its option, either (1) repair the affected product with
new or refurbished parts, or (2) provide a replacement. Any incidental costs, including the cost of
shipment from the user's location to the point of repair and return, and any installation performed by the
user, shall be at the expense of the user.
This warranty covers normal use only and shall be void in the event that the System is altered or modified
without authorization by Vision, or is subject to abuse, neglect, or other misuse by the user.
© 2019 Vision Engraving Systems
Hide quick links:
Advertisement
Table of Contents
