Fujitsu PRIMERGY BX600 User Interface Description page 219

User Account Management Commands
This command adds a new user (account) if space permits. The account <username> can be
up to eight characters in length. The name may be comprised of alphanumeric characters as
well as the dash ('-') and underscore ('_'). The <username> is not case-sensitive.
Six user names can be defined.
This command changes the password of an existing operator. User password should not be
more than eight characters in length. If a user is authorized for authentication or encryption is
enabled, the password must be eight alphanumeric characters in length. The username and
password are not case-sensitive. When a password is changed, a prompt will ask for the
operator's former password. If none, press enter.
Syntax
username <username> {password | nopassword}
no username <username>
<username> - is a new user name (Range: up to 8 characters).
no - This command removes a user name created before.
Note: The admin user account cannot be deleted.
nopassword - This command sets the password of an existing operator to blank. When a
password is changed, a prompt will ask for the operator's former password. If none, press
enter.
Default Setting
No password
Command Mode
Global Config
7.8.2.2 username snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The
valid authentication protocols are none, md5 or sha. If md5 or sha are specified, the user
login password will be used as the snmpv3 authentication password. The <username> is the
login user name for which the specified authentication protocol will be used.
Syntax
username snmpv3 authentication <username> {none | md5 | sha}
no username snmpv3 authentication <username>
218
Command Reference
Intelligent Blade Panel Module