Serial Interface Commands - Fujitsu PRIMERGY BX600 User Interface Description

Management Commands
Syntax
ip filter <ipaddr>
no ip filter <ipaddr>
<ipaddr> - Configure a IP address to be a filter.
No - Remove this filter IP address.
Default Setting
None
Command Mode
Global Config

7.5.2 Serial Interface Commands

7.5.2.1 show line console
This command displays serial communication settings for the IBP.
Syntax
show line console
Default Setting
None
Command Mode
Privileged Exec
Display Message
Serial Port Login Timeout (minutes): Specifies the time, in minutes, of inactivity on a
Serial port connection, after which the IBP will close the connection. Any numeric value
between 0 and 160 is allowed, the factory default is 5. A value of 0 disables the timeout.
Baud Rate: The default baud rate at which the serial port will try to connect. The available
values are 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 bauds.
Character Size: The number of bits in a character. The number of bits is always 8.
Flow Control: Whether Hardware Flow-Control is enabled or disabled. Hardware Flow
177
Command Reference
Intelligent Blade Panel Module