Table of Contents
Advertisement
Friedrich PTAC Accessories (continued)
ADDITIONAL ACCESSORIES
MODEL NUMBER
SLEEVE EXTENSION RETROFIT KIT G-90 zinc coated
steel, 2.4" sleeve extension attached to the room side of
PXSE
the sleeve to allow for the installation of a P-Series Friedrich
PTAC in a T-Series sleeve.
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP
unit and provides a transition to direct up to 35% of the total
CFM to a secondary room, either left or right of the unit. Kit
PXDA
includes duct plenum with discharge grille and internal baffle,
adapter and end cap.
LATERAL DUCT EXTENSION A three foot insulated plenum
that attaches to the left or right side of the duct adapter. The
PXDE
extension can be cut to length by the installer. Maximum
allowable straight extension is fifteen feet.
REPLACEMENT FILTER PACK These are original
PXFT
equipment return air filters. They are reusable and can be
cleaned by vacuuming, washing, or blowing out, and are sold
in convenient ten packs. (Two filters per chassis)
CHASSIS OPTIONS
DESIGNATOR
S
STANDARD UNIT Standard PTAC/PTHP chassis. Can be 230/208V or 265V, electric or heat pump.
R
REMOTE THERMOSTAT Chassis option necessary for wall mounted thermostat control of the unit.
SEACOAST PROTECTION Additional protection for PTAC/PTHP units in a coastal or corrosive environment.
C
The entire outdoor coil is submerged in a specially formulated enamel coating, then oven-cured for a tough,
corrosion-resistant finish.
920-087-02 (9-03)
DESCRIPTION
DESCRIPTION
PHOTO
PXSE
PXDA
PXFT
23
Hide quick links:
Advertisement
Table of Contents
