Table of Contents
Advertisement
Model 90100
Operators Manual
1. Position the instrument on its display face.
Model 35360A
TRACKER Display
Rear Panel
Fuse Drawer
Figure 4-6. Model 35360A TRACKER Display Fuse Replacement
2. Remove the fuse drawer. With your fingernails, squeeze together the two ends of the fuse drawer
and pull it out of its slot.
3. Replace the fuses with IEC 127 type FST5X20, 0.63 A, 250 V time-lag fuses.
4. Place the fuse drawer back into its slot. Press on the fuse drawer firmly until it snaps back into
place. Both sides of the fuse drawer should snap into place.
4-8
COMPUTER
INTERFACE
RS-232
100-240V 50/60 Hz 50VA
WARNING
Use only the recommended fuse type. The use of
a higher current rating than specified above may
cause damage to the instrument, which will void
any or all warranties currently in effect.
If fuses continue to blow - return instrument for
repair.
DETECTOR INPUT
!
Fuses
Fuse Drawer
NOTE
Advertisement
Table of Contents
