Power Indicator - Panasonic PT-DS20KU Operating Instructions Manual

Power indicator

The power indicator displays the status of the power. Check the status of the power indicator <ON (G)/STANDBY
(R)> before operating the projector.
Indicator status
No illumination or flashing
Red
Green
Orange
Note
z In about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp
indicators will not light up even if the power is switched on. After the power indicator <ON (G)/STANDBY (R)>
lights in red, turn on the power again.
z The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red).
Refer to "Power consumption" (
z The power indicator <ON (G)/STANDBY (R)> will flash in green if a remote control signal is received.
z The power indicator <ON (G)/STANDBY (R)> will flash slowly in green while the shutter is closed. (
z If the power indicator <ON (G)/STANDBY (R)> is flashing in red, consult your dealer.
Power indicator <ON (G)/STANDBY (R)>
The main power is switched off.
The power is switched off. (Standby mode.)
Projection will start if the power on < > button is pressed.
Lit z The projector may not operate when the lamp indicators
<LAMP1>/<LAMP2>/<LAMP3>/<LAMP4> or temperature indicator
<TEMP> is flashing (
Lit Projecting.
The projector is preparing to switch off the power.
Lit The power is switched off after a while. (Changes to the standby
mode.)
page 172) for the power consumption.

Switching on/off the projector
Status
page 142).

page 58)

ENGLISH - 49