[Clock Phase]; Pt-Ds20Ku Only); Geometry] (Pt-Dz21Ku And Pt-Ds20Ku Only) - Panasonic PT-DS20KU Operating Instructions Manual

[POSITION] menu

[CLOCK PHASE]

You can adjust to achieve an optimal image when
there is a flickering image or smeared outlines.
1) Press ▲▼ to select [CLOCK PHASE].
2) Press ◀▶ or the <ENTER> button.
▶
z The [CLOCK PHASE] individual adjustment
screen is displayed.
3) Press ◀▶ to adjust the level.
▶
z Adjustment value will change between [0] and
[31]. Adjust so that the amount of interference is
at a minimum.
Note
z Certain signals may not be adjustable.
z Optimal value may not be achieved if the output
from the input computer is unstable.
z Optimal value may not be achieved when there is a
shift in the total dot numbers.
z [CLOCK PHASE] can be adjusted only when a
signal is input to the <RGB 1 IN> terminal or the
<RGB 2 IN> terminal.
z [CLOCK PHASE] cannot be adjusted when a digital
signal is input.
z If you press ▶ while the adjustment value is [31],
the value will become [0]. If you press ◀ while the
adjustment value is [0], the value will become [31].
74 - ENGLISH
[GEOMETRY]
(PT-DZ21KU and

PT-DS20KU only)

Correct various types of distortion in a projected
image.
Unique image processing technology enables
projection of a square image on a special screen
shape.
1) Press ▲▼ to select [GEOMETRY].
2) Press ◀▶ to switch the [GEOMETRY]
setting.
▶
z The setting will change as follows each time
you press the button.
[OFF]
[PC]
Does not perform geometric
[OFF]
adjustment.
Adjusts any trapezoidal distortion in
[KEYSTONE]
the projected image.
Adjusts any curved distortion in the
[CURVED]
projected image.
Uses the computer to perform
[PC] *1
geometric adjustment.
*1: Advanced skills are necessary to use a computer to control
geometric adjustment. Consult your dealer.
3) Select [KEYSTONE] or [CURVED]
in Step 2), and press the <ENTER>
button.
▶
z The [GEOMETRY:KEYSTONE] or
[GEOMETRY:CURVED] screen is displayed.
4) Press ▲▼ to select the item you want
to adjust, and press ◀▶ to adjust the
correction amount.
▶
z The projected image can be corrected.
■ [KEYSTONE] ▶
▶
z[LENS THROW RATIO]
Set the throw ratio for the lens used.
▶
z[VERTICAL KEYSTONE]
[KEYSTONE]
[CURVED]