[Large Screen Correction] - Panasonic PT-DS20KU Operating Instructions Manual

■ To use a colorimeter to adjust the ▶
color matching
Use a colorimeter that can measure chromaticity
coordinates and luminance to change the colors
[RED], [GREEN], [BLUE], [CYAN], [MAGENTA],
[YELLOW], and [WHITE] to desired colors.
▶
zInputting the current luminance and
chromaticity coordinates
1) Press ▲▼ to select [COLOR
MATCHING].
2) Press ◀▶ to select [709MODE] or
[MEASURED].
3) Press the <ENTER> button.
▶
z The [709MODE] or [MEASURED MODE]
screen is displayed.
4) Press ▲▼ to select [MEASURED
DATA].
5) Press the <ENTER> button.
▶
z The [MEASURED DATA] screen is displayed.
6) Measure the luminance (Y) and the
chromaticity coordinates (x, y) using
the colorimeter.
7) Press ▲▼ to select a color, and press
◀▶ to adjust the setting.
▶
z Set [AUTO TESTPATTERN] to [ON] to display
a test pattern of selected colors.
8) Once all the input is completed, press
the <MENU> button.
▶
z The [709MODE] or [MEASURED MODE]
screen is displayed.
▶
zInputting the coordinates of desired
colors (for [MEASURED] only)
9) Press ▲▼ to select [TARGET DATA].
10) Press the <ENTER> button.
▶
z The [TARGET DATA] screen is displayed.
11) Press ▲▼ to select a color and press
◀▶ to input coordinates for desired
colors.
▶
z Set [AUTO TESTPATTERN] to [ON] to display
a test pattern of selected colors.
12) Once all the input is completed, press
the <MENU> button.
Note
z When [709MODE] is selected in [COLOR
MATCHING], the ITU-R BT.709 standard three
primary colors are set as target data.
z Colors are not displayed properly when target data
is a color outside the region of this projector.
z The [709MODE] may differ slightly from the ITU-R
BT.709 standard colors.
[DISPLAY OPTION] menu
z Set the [AUTO TESTPATTERN] to [ON] to
automatically display a test pattern for use in
adjusting the selected adjustment colors.
z Before using a colorimeter or similar instrument to
measure measurement data, set [PICTURE MODE]
to [DYNAMIC].
z A difference in the color coordinates of target
data and measurement values obtained from an
instrument may occur for certain instruments and
measurement environments used.
z The [AUTO TESTPATTERN] setting s change
in conjunction with the [AUTO TESTPATTERN]
settings in [EDGE BLENDING].
[LARGE SCREEN
CORRECTION]
Corrects the phenomenon in which colors that appear
lighter when viewed on a large screen viewed from
a close distance compared to when viewed on an
average screen size so that colors appear the same.
1) Press ▲▼ to select [LARGE SCREEN
CORRECTION].
2) Press ◀▶ to switch [LARGE SCREEN
CORRECTION].
▶
z The setting will change as follows each time
you press the button.
[OFF] (No
[1] (Low)
correction)
[2] (High)
ENGLISH - 89