Panasonic PT-DS20KU Operating Instructions Manual page 107

10) Press ◀▶ to switch [COMMAND].
▶
z The setting will change as follows each time
you press the button.
[POWER ON] [STANDBY]
[LAMP
[P IN P] *1
SELECT]
*1: Displays the details set in Step 12).
11) Press the <ENTER> button.
▶
z The [COMMAND] detailed setting screen is
displayed.
12) Press ▲▼ to select a command.
▶
z For [SHUTTER], [INPUT], [LAMP SELECT],
and [P IN P], the setting will change as follows
each time you press the button.
▶
z[SHUTTER]
[OPEN]
▶
z[INPUT]
[RGB1] [RGB2]
[SDI2] *1
[SDI1] *1
*1: PT-DZ21KU and PT-DS20KU only
▶
z[LAMP SELECT]
[SINGLE]
[QUAD]
▶
z[P IN P]
[OFF]
[USER3]
13) Press the <ENTER> button.
▶
z The command is fixed and ● is displayed at the
left of the selected command.
▶
z After the command is fixed, press the <MENU>
button to close the detailed setting menu.
14) Press ▲▼ to select [STORE], and
press the <ENTER> button.
[SHUTTER]
*1
[INPUT] *1
*1
[CLOSE]
[VIDEO]
[DVI-D]
[HDMI]
[DUAL]
[TRIPLE]
[USER1]
[USER2]
[PROJECTOR SETUP] menu
Note
z If you try to register a setting that would cause the
lamp to flash for a short time, an error message
will be displayed on the screen. Set the time and
command again.
z To delete a command already set, press the
<DEFAULT> button on the Step 6) screen, or select
[DELETE] on the Step 7) screen and press the
<ENTER> button.
z If multiple commands have been set for the same
time, they are executed in chronological order
starting from the smallest command number.
z The operating time will be the local time. (
z If an operation is executed with the remote control
or control panel of the projector or with a control
command before the command set in [SCHEDULE]
is executed, the command set with this function
may not be executed.
page 110)

ENGLISH - 107