Ricoh Aficio SP C232SF User Manual page 306

Troubleshooting
Message
Near Memory Full
Net Communication Error
Press Clear Key
NetBIOS Name Conflicted
Press Clear Key
Network Is Not Ready Press
Clear Key
No Profile Exist
Outer Jam
Please Reboot System
9
RX Comm. Error
Scan Network Disconnect
Press Clear Key
Scan USB Disconnect
Server Connection Failed
Press Clear Key
296
Causes
Memory has almost reached
capacity during sort copy.
Connection with the server
was lost while sending or re-
ceiving data.
The NetBIOS name specified
for the machine is already in
use by another device on the
network.
A scanned file could not be
sent because the machine has
not received IP address infor-
mation from the DHCP server
completely.
No Quick Dial entry is associ-
ated with the One Touch but-
ton you pressed.
Paper has been jammed in the
machine.
An error occurred and the ma-
chine cannot continue to oper-
ate.
A reception error occurred,
and the fax could not be re-
ceived correctly.
A scanned file could not be
sent because the Ethernet cable
was not connected properly.
The USB cable was discon-
nected while scanning from a
computer.
A scanned file could not be
sent because the destination
could not be reached.
Solutions
If several originals are still to
be scanned, it is recommend-
ed to start printing now, and
copy the remaining originals
separately. If originals are be-
ing scanned from the ADF, re-
move any remaining pages
from the ADF.
Contact the network adminis-
trator.
Change the NetBIOS name.
See p.257 "Configuring the
Network Settings".
Wait until the machine re-
ceives the IP address informa-
tion completely, and then try
the operation again.
• Press a different One
Touch button.
• Assign a registered desti-
nation to the One Touch
button. See p.138 "Regis-
tering Scan Destinations".
Remove the jammed paper.
See p.272 "Removing Printing
Jams".
Turn off the power, and then
turn it back on.
If possible, contact the sender
of the fax and ask them to re-
send it.
Reconnect the Ethernet cable
properly, and then try the op-
eration again.
Reconnect the USB cable
properly, and then try the op-
eration again.
Confirm that the destination is
registered correctly, and then
try the operation again.