About This Appendix; Power-Up Troubleshooting - Oki B6100n Configuration Manual

B-2 Ethernet Network Interface Card Configuration Guide

About this Appendix

Power-Up Troubleshooting

Message
Power-up diagnostic failure (hardware
failure)
The NIC boots but does not try to load
the Flash ROM code
Network Error: The ACT LED will
blink yellow 2-3 times per second
Error Messages
Diagnosis/Remedy
Note which LED is blinking and its color, then contact
your dealer or Technical Support.
Briefly press the Test button on the NIC's I/O panel. A
NIC configuration page will be printed. (To press the
Test button, you will need a pointed object - e.g. paper
clip.)
Make sure the Ethernet network cable is properly
connected and reboot the server.