Table of Contents
Advertisement
Quick Links
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY
THIS MANUAL IS PRINTED ON RECYCLED PAPER
O W N E R S M A N U A L
WHAT TO DO IF YOU SMELL GAS
• Open windows
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
Do not store or use gasoline or other Flammable vapors and liquids in the vicinity of
EG 28 B Vented
FOR YOUR SAFETY
this or any other appliance.
B y S H E R W O O D I N D U S T R I E S
WARNING
If the information in this manual
is not followed exactly, a fire or
explosion may result causing
property damage, personal
injury or loss of life. Installation
and service must be performed
by a qualified installer, service
agency or the gas supplier.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Enviro Vented EG 28 B
Summary of Contents for Enviro Vented EG 28 B
- Page 1 SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER EG 28 B Vented O W N E R S M A N U A L WHAT TO DO IF YOU SMELL GAS • Open windows •...
-
Page 2: Safety Precautions
FOR SAFE INSTALLATION AND OPERATIONOF YOUR "ENVIROGAS" STOVE, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: GENERAL • Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at once least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. -
Page 3: Table Of Contents
Safety Precautions Code Approvals Deciding where to locate your stove Venting Installation of Log Sets and Embers Operating Instructions Maintenance and Technical Trouble Shooting Gas Line Connection Electrical Parts and Accessories Fuel Type Conversion Warranty Parts List Exploded Views Installation Data Sheet •... -
Page 4: Deciding Where To Locate Your Stove
DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: Front Width: 22"/ 56cm Rear Width: 22"/ 56cm Height: 27-1/2"/ 70cm* Depth 19"/ 48cm (*not including vent coupling) Shipping Weight: 210 lbs/95 kg CLEARANCES: A. Side wall to stove 10"/ 25cm B. Rear wall to stove C. -
Page 5: Vent Terminal Clearances
VENT TERMINAL CLEARANCES Figure 3 A= Clearance above grade, verandah, porch, deck, or [balcony (*12 inches (30cm) minimum] B= Clearance to window or door that may be opened [*12 inches (30cm) minimum] C= Clearance to permanently closed window [minimum 12 inches (30cm) recommended to prevent condensation on window] D= Vertical clearance to ventilated soffit located above the terminal within a horizontal... -
Page 6: Venting
This model must have a vent opening in the rear of the unit. Confirm this and also check that the label on the right side panel door states "Vented Room Heater". WARNING: THIS APPLIANCE HAS BEEN DESIGNED TO OPERATE BY DRAWING COMBUSTION AIR AND DILUTION AIR FROM THE ROOM. -
Page 7: Using An Existing Chimney
A. USING AN EXISTING CHIMNEY • Measure the height of the chimney beforehand and purchase the appropriate kit. Never attempt to over stretch a flexible liner to accommodate the height of the chimney. • Any flue damper must be removed or locked permanently in the open position. -
Page 8: Installation Of Log Sets And Embers
INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of Rock Wool embers is provided for use on the burner tray. CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. -
Page 9: Operating Instructions
OPERATING INSTRUCTIONS WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot, which must be lit by hand by following these instructions exactly. B) BEFORE LIGHTING smell all around the appliance area for gas, and next to the floor because some gas is heavier than air and will settle on the floor. -
Page 10: Maintenance And Technical
MAINTENANCE AND TECHNICAL Annually check to ensure that your Venting system is clear. Periodically check the pilot and burner. Check to see that all the burner ports are clean and clear. Check the pilot head for blockage. Check to ensure the pilot flame is blue with small yellow tips. - Page 11 Problem Spark will not light the pilot after repeated pressing of spark igniter Pilot will not remain lit Burners will not remain lit Flame lifting Glass fogs up Blue flames Flames are burning “dirty” or Sooting Possible Cause Defective piezo igniter Broken spark electrode Miss-aligned spark electrode Problem with thermocouple circuit...
-
Page 12: Gas Line Connection
ORIFICE SIZES, PRESSURE AND BTU’S Orifice size Manifold pressure. Min. Manifold pressure. Supply Pressure. Min. Supply pressure. Max. BTUH Input. Min. BTUH Input. Output fan off Output fan on WARNING: Only persons licensed to work with gas piping may make the necessary gas connections to this appliance. NOTE: The gas line connection may be made using 3/8"... - Page 13 The ENVIROGAS EG 28.FS.BV. will operate with no external power supply. These models have a Millivolt gas control which uses the pilot flame to generate enough electricity to operate the main burner. The appliance when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE.
-
Page 14: Parts And Accessories
Service Parts available from your local Envirogas Dealer Burner Control Assembly Natural Gas Pilot Assembly Propane Pilot Assembly Door Bolt Relief Door Gasket Regulating Valve Piezo Igniter Burner Switch B-vent Spill switch 220° Orifice Blank Gold trim Package Low Voltage Thermostat REMOVING or INSTALLATION OF THE BLOWER 1. -
Page 15: Fuel Type Conversion
ADJUSTING THE VENTURI • Remove the ash shelf by undoing the screw at each end, pull shelf towards you. • Remove one screw from the cover plate located below the ash shelf. Loosen the other screw (do not remove) swing the cover plate out of the way and tighten screw down to hold it in place. -
Page 16: Warranty
Because of our high standards Sherwood Industries Ltd. can offer a *Lifetime Warranty on all it’s gas products. Covered under this warranty are Cabinet Sides, Tops, Pedestals, Surround Panels and Chassis. These steel components are covered against manufacture’s defects for 5 years and labour for the first years and for parts only thereafter. -
Page 17: Parts List
EC-001 120° F CERAMIC TEMP SENSOR EC-002 220° F CERAMIC SPILL SWITCH EC-006 SIT NOVA 820 NG VALVE 50% EC-007 SIT NOVA 820 LP VALVE 50% EC-009 THERMOCOUPLE (POST 10/00) EC-011 SPARK ELECTRODE w/CABLE EC-012 THERMOPILE EC-013 PILOT NG w/ELECTRODE EC-014 PILOT LP w/ELECTRODE EC-015... -
Page 18: Exploded Views
BV 4” CRIMPED 120 ° F (49° C) FLUE PIPE CERAMIC FAN EG28-169 TEMP SENSOR DV 4” EC-001 FLARED FLUE PIPE EG28-170 CONVECTION BLOWER EC-030 FS FAN MOUNTING BRACKET EG28-304 WIRE CHANNEL EG28-139 220° F (104° C) CERAMIC SPILL SWITCH EC-002 1 X 1 SIDE CABINET... - Page 19 PAN BURNER TOP BURNER CONTROL ASSEMBLY COMPLETE EG28-143 NG EG28-145 LPG VENTURI TUBE BURNER BRACKET ORIFIC BLANK EC 022 CONTROL PANEL FS FAN CONTROLLER EC-038 EG28 DOOR AND GAS TRAY ASSEMBLY EXPLODED Page 1 of 2 FULLY ASSEMBLED PILOT EC-015 NG , 016 LP THERMOPILE EC-012 THERMOCOUPLE...
-
Page 20: Installation Data Sheet
INSTALLATION DATA SHEET The following information must be recorded by the installer for warranty purposes and future reference. Model: EG 28 B vented Name of Owner: __________________________________________ Address: __________________________________________ __________________________________________ __________________________________________ Phone:_____________________________________ • Model :___________________________________ • Serial Number: __________________ • Date of Purchase: __________/________/________ •...
Need help?
Do you have a question about the Vented EG 28 B and is the answer not in the manual?
Questions and answers