Management; Switch Configuration Using Webview; Switch Configuration Using Cli Commands; Standards Compatibility - Enterasys SecureStack B2 B2G124-24 Hardware Installation Manual

Management

Management of the module can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks' NetSight
application, or the WebView application. Out‐of‐band management is provided through
the DB9 Console port connector on the front panel using a VT100 terminal or a VT100
terminal emulator.

Switch Configuration Using WebView

Enterasys Networks' HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.

Switch Configuration Using CLI Commands

The CLI commands enable you to perform more complete switch configuration
management tasks.
For CLI command set information and how to configure the module, refer to the
SecureStack B2 Configuration Guide.

Standards Compatibility

The 1000BASE‐T ports are compliant with the following standards and operations:
• IEEE 802.3
• IEEE 802.3u
• IEEE 802.3ab
• Full‐Duplex operation
The SFP ports are compliant with the following standards and operations:
• IEEE 802.3z
• IEEE 802.3x Flow Control support for Full‐Duplex mode
• Auto‐negotiation for Full‐Duplex control operations

LANVIEW Diagnostic LEDs

LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an
easy way to observe the status of individual ports and overall network operations.
®
management
SecureStack B2 Installation Guide
Management
1-7