Installing The Network Expansion Module - Enterasys Gold Distributed Forwarding Engine 4G4205-72 Hardware Installation Manual

Poe modules dfe-gold series

Table of Contents

Figure B-9

Installing the Network Expansion Module

1 NEM

2 Front panel

Use two of the saved coverplate screws to fasten the NEM to the DFE module front

panel, but do not tighten screws at this time.

Insert the saved standoff through the NEM to the standoff on the main board. Screw

in the standoff, but do not tighten screws at this time.

Tighten the two coverplate screws first, then the standoff.

3 NEM connectors

4 Main board connectors

Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-13

Gaining Access to Memory Modules

5 Coverplate screws (2)

6 Standoff

Table of Contents

Do you have a question about the Enterasys Gold Distributed Forwarding Engine 4G4205-72 and is the answer not in the manual?