Gaining Access to Memory Modules
Figure B-4
1 Coverplate screws (2)
2 NEM
3 DFE module front panel
2.
Remove the two screws fastening the NEM to the DFE module front panel and
remove the standoff fastening the NEM to the main board. Save the two screws and
standoff for later use to reinstall the NEM.
3.
Lift and remove the NEM off the two main PC board connectors. Now you have
access to the DIMM. To replace the DIMM, proceed to "Removing the DIMM" on
page B‐10.
B-8 Mode Switch Settings and Option Installations
Removing the Network Expansion Module (NEM
)
4 Standoff
5 Main PC board
6 Main board connectors