Assembly; Tools Required For Assembly - Craftsman 486.244121 Owner's Manual

ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) 7/16" Open End or Box Wrench
(1) 1/2" Open End or Box Wrench
(1) 9/16" Open End or Box Wrench
(1) 3/4" Open End or Box Wrench
(1) Adjustable Wrench
(1) Hammer
Refer to carton contents figure on page 2 and
figure I on page 3 for parts and hardware needed
to assemble dozer blade.
.
NOTE
RIGHT HAND (R.H.) AND LEFT HAND
(L.H.) ARE DETERMINED FROM
OPERATOR'S POSITION WHILE
SEATED ON TRACTOR.
Assemble curved end of angle lock spring into
small hole in washer as shown in figure 2.
T
/
ANGLE LOCK SPR,NG /
CHANNEL/PIVOT
PLATE ASSEMBLY
FIGURE 2
,
Assemble the two angle lock bars together as
shown in figure 3, using one 3/8" x 1-1/4" carriage
bolt down through the top holes with a 3/8" lock
washer and a 3/8" hex nut underneath. Do not
tighten at this time.
3/8" X 1-114"
DARRIAGE BOLT
(TOP HOLE
ANGLE
LOCK BARS
_,_.--''_3_"HEX NUT
(_ 3/8"LOCK
WASHER
.OCK BAR
SLOT
SPRING PIN
HOLE
CHANNEL/PIVOT
PLATE ASSEMBLY
FIGURE 3
ANGLE LOCK
SPRING
.
Assemble the offset end of angle lock spring into
small holes in angle lock bars as shown in figure
3. Slide lock bars through lock bar slot until spring
pin hole is aligned with bracket on back side. See
figure 4. Using a hammer drive 1/4" x 1 "spring pin
into lock bars until flush with bracket. See figure
4. Tighten nut in angle lock bars which was left
loose in step 2.
FIGURE 4
rs_ NOTE
Lock ba pivot freely and when
pulled all the way back the channel/pivot
plate assembly should be unlocked and
free to pivot to right or left position notches.