Canon MultiPass C530 User Manual page 11

Canon recommends an individual line following industry standards [e.g., the 2500 (touch tone)
or 500 (rotary/pulse dial) telephones]. A dedicated extension off a PBX without "Camp On"
signals is also permissible with your MultiPASS. Key telephone systems are not recommended
because they send non-standard signals to individual telephones for ringing and special codes,
which may cause a fax error.
NOTICE
C°
Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should
be independent from copiers, heaters, air conditioners or any electric equipment that is
thermostatically controlled. The rated value is 120 volts and 15 amperes. The RJll-C
modular jack should be relatively close to the power outlet to facilitate installation.
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets telecommunications networks protective, operational and safety requirements
as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The
Department does not guarantee the equipment will operate to the user's satisfaction.
Preface xi