Brother MFC370MC Service Manual page 32

3.10 Document Draw Adjustment
After reptacement of the main PCB or CIS, or it data _to,ud in the EzPHOM is damaged, you ,,uud to
carry out this procedure.
• Function
This function adjusts how much the document is drawn in, starting at the point when the
document rear sensor is turned on until the leading edge of the document reaches the scan-
ning start position.
• Operating Procedure
(1) In the initial maintenance mode, set the T0-025 chart on the document stacker.
The message "DOC.READY" appears on the LCD.
(2) Press the _ key.
The equipment beeps and draws in the TC-025 chart to the scanning start position.
While drawing it in, the equipment counts patterns on the chart to determine the amount
of draw.
Upon completion of normal counting, the equipment shows the message "COPYING
P.01" on the LCD and begins copying the TC-025 chart. The message "REAR SEN-
SOR IS ADJUSTED" and the copied image will be printed out on recording paper as
shown below.
If any error occurs during counting, the message "MACHINEERROR AB" appears on
the LCD, with no copying of the TC-025 chart onto the recording paper taking place.
However, only the message "REAR SENSOR IS ADJUSTED" will be printed out.
TC=_25
1996.8.29
im:'-"_ i lllililll
/
I_
r I'
"c731snr(I SI 105N35
Printout after Normal Completion of Document Draw Adjustment
V-48-1