Brother MFC370MC Service Manual page 29

WSW26 (Function setting 4)
Selector
No.
2
3
Function
Application of DC wetting pulse
Overvoltage limiter at the apply-
ing time of a wetting pulse
Not used.
No. of CNG cycles to be detected
(when the line is connected via the
external telephone except in the
external TAD mode)
No. of CNG cycles to be detected
(when the line is connected via
the external telephone in the
external TAD mode or via the
facsirnile equipment in F/T mode)
NO.
No.
0:
0:
Setting and Specifications
OFF 1" ON
ON 1: OFF
i
4 5
0 0 : No detection (A)
0 1 : 1 (B)
1 0 : 1.5 (C)
1 1 : 2 (D)
6 7
0 0 : 0.5 (A)
0 1 : 1 (B)
1 0 : 1.5 (C)
11 : 2 (D)
_,_;_ FAX reception after the time-out of
pseudo rinq backtones in F/T mode .... 0; YES 1" NO
=
T,,,,, .....
Selectors 1 and 2: Application of DC wetting pulse and overvoltage limiter
These selectors take effect only when the UK version of the facsimile equipment is set up for
the British Telecom's caller ID service or its equivalent.
Selector 2 takes effect only when selector I is set to "1 ."
• Selectors 4 and 5: No. of CNG cycles to be detected
The equipment interprets a CNG as an effective signal if it detects a CNG signal by the num-
ber of cycles specified by these selectors when the line is connected via the external tele-
phone except in the external TAD mode.
Selectors 6 and 7: No, of CNG cycles to be detected (For those models not equipped with a
built-in TAD)
The equipment interprets a CNG as an effective signal if it detects a CNG signal by the num-
ber of cycles specified by these selectors when the line is connected via the external tele-
phone in the external TAD mode or via the facsimile equipment in F/T mode.
Selector 8: FAX reception after the time-out of pseudo ring bscktones In F/T mode
If this selector is set to "0," the equipment enters the facsimile receive mode after issuing
pseudo ring backtones. If it is set to "1," the equipment disconnects the line after issuing
pseudo ring backtones.
V - 37