Brother MFC370MC Service Manual page 24

(5) Litt up the ACS gluulldlny _prlny.
• Reassembling Notes
Before putting the scanner frame ASS¥ 0ack, onto the main frame, be sure to set the ,_L;S
grounding spring as illustrated on the previous page.
Make sure that tabs "A" of the scanner frame ASSY are fitted in cutouts "B" provided in
the main frame. (See the illustration on the previous page.)
After putting the scanner frame ASSY back onto the main frame, route the harnesses and
arrange the cores as follows, referring to the illustration below.
Hook the power supply harness core on boss "C."
- Check that the cutter HP sensor harness runs through a core, and then hook the core
on boss "D."
- Push the ClS harness core and the recording head hamess core into position, to the
left of rib "E" and behind relay "F."
- Route all these harnesses under boss "D."
If any of these harnesses and cores are out of the specified position, the scanner frame
ASSY or ROM cover may not be put back into place.
After connecting these harnesses, check that neither the electrolytic capacitor nor resis-
tors are tilted towards the PE sensor actuator. If tilted, they may interfere with normal op-
eration of the sensor actuator.
Cutter HP sensor
Boss=C" Power supplyharness harness
Motor harness
BOSS "D"
I (Rear)
Relay =F" Rib =E" Resistors
Sotenoid Recording
harness head harness
Main PCB
CIS harness
Electrolytic
capacitor
PE sensor actuator
IV- 13