Brother MFC370MC Service Manual page 23

1.6 Scanner FrameASSY
(1)
(2)
(3)
(4)
Be sure to swing the recordiny head release lever (blue lever) down to the front pos=-
tion.
Remove the two screws.
Slightly lift up the rear edge of the scanner frame ASSY and disconnect the following
five harnesses from the main PCB:
• Cutter home position (HP) sensor harness (2-pin)
• ClS harness (7-pin)
• Recording head harness (12-pin)
• Solenoid harness (2-pin)
• Motor harness (6-pin)
Lift up the scanner frame ASSY from the rear and take it out from the main frame.
NOTE: Do not hold the lower paper chute but the upper paper chute. The lower pa-
per chute is easily deformed.
Upper paperchute
(Hold here.)
handling
Scanner frame ASSY
Lower paper chute
(Do not hold here.)
frame
liB.
(NCU connector)
ACS grounding spring
Cutter HP sensor harness (2-pin)
or--]
/ \
Main PCB
Motor harness (6-pin)
Recording head harness
J (12-pin)
ClS harness (7-pin)
Solenoid harness (2-pin)
[V- 12