Installing the power jumper
If the blade server system board is equipped with power connector J164, complete
the following steps to install the power jumper.
Note: A power jumper can not be installed when installing a Memory and I/O
Expansion Blade.
1. Locate the power connector J164 on the system board.
2. Place the power jumper into the power connector, and press the power jumper
3. Install the blade server cover (see "Installing the blade server cover" on page
4. Install the blade server into the BladeCenter unit (see "Installing the blade
44
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
Power jumper
until it is fully seated.
25).
server in a BladeCenter unit" on page 22).