For Simple Stack Users - Hitachi CP-X4021N User Manual

For Simple Stack users

1.
Press MENU
2.
Use the ▲/▼/◄/► buttons to open
TEMPLATE dialog, then select
the dialog. (Operating Guide
menu)
3.
Press MENU
B to open a menu.
4.
Use the ▲/▼/◄/► buttons to select
PERFECT FIT
and OPTION
(Operating Guide
TION menu).
PERFECT FIT
5.
Using PERFECT FIT
age size and position of
pose to the image of
It is recommended to adjust it by the following
way.
(1) Adjust four corners roughly in turn as below.
Top left → Top right → Bottom right → Bottom left.
(2) Adjust four corners finely in turn as same as above.
for all users • Refer to
NOTE
menu in the Operating Guide
• Even if you place two projectors side by side
position of one projector to the other's with the same way as explained above.
• It is strongly recommended to use a flat screen. If you use a curved or
distorted screen, it is very difficult to adjust two images to be superimposed,
even if you use pin/barrel adjustment on
• Even though you try to finely adjust the images from two projectors, it may
not be possible to superimpose the images depending on input signals. In this
case, try to resolve it with the following measures.
AUTO
- Press button of the remote control or execute
EXECUTE ( Operating Guide
- Adjust H POSITION
on each of the projectors.
- Check RESOLUTION
the two projectors, change the setting to the same.
INPUT menu)
button on the remote control to open a menu on
button on the control panel of
that is existed in
menu of ADVANCED
→ EASY MENU
dialog appears on screen.
on Set B, adjust the im-
Set B
Set A.
for the detail of
and V POSITION
setting on
STACK on
→
SCREEN
Set
EASY MENU
MENU.
or OP-
to fully superim-
PERFECT FIT of
PERFECT
(Style
PERFECT
→ IMAGE menu) on each of the projectors.
(Operating Guide
INPUT menu, and if it is different between
16
Set
STACK of TEMPLATE
PERFECT FIT
on STACK of
EASY MENU or
FIT.
2), adjust the image
FIT.
AUTO ADJUST
→ IMAGE
(Operating Guide
Installation
A.
dialog
TEMPLATE
OPTION
menu)
→