Setting Up Set B - Hitachi CP-X4021N User Manual

Setting up Set B

1.
Turn on Set B.
• After turning on
NOTE
remarkably inclined compared with the image of
much, rotate the elevator feet of
again that there is about 1 mm space between a protrusion at the bottom of
Set B and the top case of
2.
Reset the adjustment by
(Operating Guide
• When you use
NOTE
is required to reset both functions, reset
3.
Adjust image size and position of
HORIZONTAL
• Fine adjustment of image size and position later by electrical
NOTE
function, such as
image size, so it is important to fully overlap the image of
adjustment.
• If you try to operate
It is recommended to operate
• If you install two projectors side by side, also adjust image size and position
of Set B to fully overlap the image of
• If you use Simple
on Set B by KEY LOCK
it by a wired remote control, since
( Operating Guide
• If you use Simple
4.
Display a menu with
function)
5.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU
> SERVICE
> STACK
STACK menu will appear on screen.
(Operating Guide
(continued on next page)
Set B, make sure that the image of
Set
A.
KEYSTONE
→ EASY MENU
PERFECT
FOCUS
adjuster and
KEYSTONE and
Set B with the remote control,
Set B
Stack, it is recommended to disable the remote control
and operate it by the control panel, or to operate
→ OPTION
Stack, go to
MENU button.
> OPTION
> COMMUNICATION
→
OPTION
Set
Set B to adjust the angle roughly. Check
and PERFECT FIT
or SETUP
FIT, KEYSTONE
PERFECT FIT
Set B with ZOOM
ring to fully overlap the image of
PERFECT FIT, cannot widen the
with the control panel on
Set A.
Set A will react to the remote control.
menu)
For Simple Stack
(Operating Guide
menu).
12
Set B
A. If it is inclined too
on Set B.
menu)
cannot be operated. If it
function first.
ring, VERTICAL
Set A by optical
Set A may react as well.
Set B.
users. ( 16 )
→ Using the menu
Installation
is not
adjuster,
Set A.