Connecting Signal Cables; Inputting Image To Sub From Main; Inputting Image To Sub And Main Individually - Hitachi CP-X4021N User Manual

4.2 Connecting signal cables

There are two options to input image to
- Inputting image to
- Inputting image to

Inputting image to Sub from Main

1.
Connect the
to COMPUTER IN1
computer cable.
2.
Connect your image device to one of input
port on Main.
for Intellectual Stack • As an
NOTE
input port on Main
COMPUTER IN1
Stack,
available. Do not use other ports for image
input.
- If you wish to input a component signal,
input it to COMPUTER IN1
- If you wish to input a video signal, input it to
Y pin of component signal on
IN1 and IN2.
for Simple Stack • As an input
NOTE
port on the projector that is connected a
computer cable to the ports
COMPUTER IN1
from MONITOR OUT
(Operating Guide
wish to use other input port, input the image
to Sub and Main

Inputting image to Sub and Main individually

1.
Split output signal from your image device to two with a signal splitter or
something similar.
2.
Connect your image device to the same input port on
projectors.
for Intellectual Stack • As an input port on
NOTE
Intellectual Stack, LAN,
for Simple Stack • As an input port on the projectors, any input
NOTE
ports which signal can be split to two are available.
Sub from the
Sub and Main
MONITOR OUT
port on Sub
projector in Intellectual
IN2
and
and IN2.
COMPUTER
MONITOR
and IN2 that can be output
port are available.
→ SETUP menu) If you
individually.
USB TYPE A
Sub projector.
MONITOR OUT
individually.
port on Main
with a
are
OUT,
and USB TYPE B
28
Connecting cables
22, 23 )
(
port on Main.
Connection example
in Intellectual stack
Main and
Main projector in
cannot be used.
Main
Sub
Sub