Table of Contents
Advertisement
Installation
For Simple Stack users
1.
Press the MENU button on the remote control to display the menu on Set A.
2.
Use the ▲/▼/◄/► buttons to open the TEMPLATE
dialog, then select STACK on the dialog.
(Operating Guide
3.
Press the MENU button on the control panel of
Set B to display the menu.
4.
Use the ▲/▼/◄/► buttons to select PERFECT
FIT from EASY MENU, or the SETUP menu of
ADVANCED MENU.
MENU
o r
SETUP
PERFECT FIT dialog appears on screen.
Set PATTERN settings to ON to display the test pattern.
5.
Using PERFECT FIT on Set B, adjust the image size
and position of Set B to superimpose well to the image
of Set A. Adjust PERFECT FIT in the following ways.
(1) Roughly adjust the four corners in the order below.
Top left → Top right → Bottom right → Bottom left
(2) Fine adjust the four corners in the same way.
NOTES for all users
EASY MENU
o r
• It is strongly recommended to use a flat screen. If a curved or skewed screen
is used, it is difficult to align the two images even if you use the pin/barrel
adjustment of PERFECT FIT.
• Even through fine adjustment of the images from the two projectors, it may not
be possible to superimpose the images depending on the input signals. In this
case, try the following methods.
- Press the AUTO button on the remote control or execute AUTO ADJUST
EXECUTE
(Operating Guide
- Adjust H POSITION and V POSITION
o n e a c h
o f t h e p r o j e c t o r s .
- Check the RESOLUTION s e
setting if the setting differs between Main and Sub.
INPUT
menu)
→
SCREEN
(Operating Guide
menu)
• For details on PERFECT FIT, refer to
SETUP menu
i n t h e
t t i n g i n t h e INPUT menu, and change to the same
menu)
→
EASY
Operating
Guide.
→
IMAGE
menu) o n e a c h
(Operating Guide
12
STACK of TEMPLATE
PERFECT FIT dialog
on STACK of TEMPLATE
PERFECT FIT
o f t h e p r o j e c t o r s .
→
IMAGE
(Operating Guide
o f
menu)
→
QM00974-1
Advertisement
Table of Contents
