Hitachi CP-X4021N User Manual page 25

Important information for Intellectual Stack
● The following functions are disabled.
- Executing of
- STANDBY MODE
- AUTO SEARCH
- Turning on/off
- DIRECT POWER ON
- MY SOURCE
- COMMUNICATION TYPE
→ COMMUNICATION)
● The input source from the following ports cannot be selected.
- USB TYPE A,
● An error message will be displayed if an error is occurred on projectors while
operating on Intellectual
When an error is occurred, a full dialog will be
displayed on screen. After around 20 seconds
without any key input, the full dialog will be turned
to a small dialog. When a small dialog is displayed,
pressing the ◄ button displays a full dialog again.
A number on projector icon means that "1" indicates
and "2" does Sub.
Refer to a message on screen as shown below and take a necessary action to
solve the problem.
Example:
Cover Error: Lamp cover is opened.
Lamp Error: Lamp does not light up.
Fan Error: Cooling fan has a problem.
Temp Error: Temperature in projector is too
high.
Air Flow Error: Check exhaust vent that may
be blocked, since temperature in projectore is
too high.
Filter Error: Filter timer counts hours more than
the setting hours on Filter Message menu.
(Operating Guide
SERVICE)
Cold Error: Air temperature around projector is
too low.
(continued on next page)
AUTO KEYSTONE
(Operating Guide
(Operating Guide
AUTO KEYSTONE
(Operating Guide
(Operating Guide
(Operating Guide
USB TYPE B, LAN
stack.
→
OPTION menu
(continued)
(Operating Guide
→ SETUP
→
OPTION
(Operating Guide
→
OPTION
→ OPTION
→
25
Setting on Stack menu
→ SETUP
menu)
menu)
→ OPTION
menu)
menu)
→ OPTION menu
Full dialog
Main projector
menu)
menu)
→ SERVICE
Small dialog