Dell B2360D User Manual page 73

Understanding the printer menus
Use
Run Initial setup
Yes
No
Paper Sizes
US
Metric
Timeouts
Sleep Mode
Disabled
1–120 min
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300 sec
To
Run the setup wizard.
Notes:
•
Yes is the factory default setting.
•
After completing the setup wizard by selecting Done at the
country or region selection screen, the default becomes No.
Specify the unit of measurement for paper sizes.
Notes:
•
US is the factory default setting.
•
The initial setting is determined by your country or region
selection in the initial setup wizard.
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
•
"30 min" is the factory default setting.
•
"Disabled" appears only when Energy Conserve is set to Off.
• Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Set the amount of time the printer waits before it enters Hibernate
mode.
Notes:
•
"Disabled" is the factory default setting in all countries
except European Union countries and Switzerland.
•
"3 days" is the factory default setting for all European Union
countries and Switzerland.
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: "Do Not Hibernate" is the factory default setting.
Set the amount of time in seconds the printer waits before the it
returns to a ready state.
Note: "30 sec" is the factory default setting.
73